New Construction Simulator Rooms, Planned Before the Drywall
The cheapest simulator inches you'll ever buy are the ones framed in from the start. We coordinate with your architect and builder so the room is right the first time.
What getting in early buys you
Once framing closes, every inch costs real money. Before it closes, inches are nearly free.
Ceiling height by design
Spec 10 ft (or more) in the simulator zone on paper, instead of negotiating with beams later.
Clean-room dimensions
Width and depth set for your screen size, both-handed play, and seating, not inherited from whatever the room happened to be.
Conduit & pre-wire
Projector power and data, launch monitor runs, speaker wire, network drops, and lighting circuits inside the walls, invisible forever.
Structural blocking
Backing framed in for projector mounts, screen frames, and ceiling-hung launch monitors, so nobody hunts for studs in a finished ceiling.
HVAC done right
Supply and return placed for a sealed, padded room full of people and electronics, planned with the mechanical contractor.
Sound isolation
Insulation and isolation details specified while walls are open, so impact crack stays in the golf room.
A clean handoff with your builder
We've coordinated AV and integration scopes with builders and architects across New Jersey through our parent studio, ynVISION.DESIGN, so new construction is familiar territory. Typically we join at design development: we supply the simulator room's dimensional requirements, electrical and data schedule, and blocking locations, then stay available to the GC through framing and rough-in walkthroughs.
After close-in, we return for the finish phase: turf, padding, screen, projection, audio, lighting scenes, launch monitor, and calibration. Your builder builds the room; we make it a simulator. One document set, no finger-pointing.
Building in Saddle River, Montville, or anywhere in between? The earlier we talk, the more options you keep. See also: custom room design and room requirements.
Frequently asked questions
When should the simulator installer get involved in a new build?
Design development, before framing is finalized. That's when ceiling height, room dimensions, conduit, and blocking cost almost nothing to change. We can join later, but every closed wall removes options.
What ceiling height should we spec for a new simulator room?
If you're specifying from scratch, 10 ft is a comfortable target that fits virtually every golfer and swing, with 9 ft 6 in as a practical minimum for worry-free driver swings. More height also improves projection options and room feel.
Do you work directly with our architect and builder?
Yes, that's the normal arrangement. We supply dimensional requirements, electrical/data schedules, and blocking plans, attend rough-in walkthroughs, and coordinate our finish installation with the GC's schedule.
What should we rough-in even if we're not buying equipment yet?
Conduit from the equipment location to the projector and screen positions, a dedicated circuit or two, network drops, speaker pre-wire, and ceiling blocking. That package keeps a future simulator clean and inexpensive to add, and we provide the spec as a standalone service.
Can this work in a major renovation, not just new construction?
Absolutely. Any project where walls or ceilings open up (basement refinishing, garage conversions, additions) gets most of the same benefits. The key is sequencing our rough-in requirements into the contractor's plan early.
Ready to plan your simulator room?
Tell us about your space and goals. We’ll confirm fit, walk you through equipment options, and put together a clear quote. No pressure, no jargon.